This guide describes how to configure a Cisco SX10 using the Startup Wizard. This wizard will be displayed on the screen on the first startup. If not, you can always launch it from the settings-menu in the upper left corner.
The first screen will look like this:
Press next and follow the guidelines until you get to the Provisioning-screen. You will be able to adjust microphone and speaker volume during this phase.
Choose VCS and type host server address, your username, password, and the domain listed below.
Use these settings (remember to check spelling):
Host server address: t.vnor.net
Press apply and wait for the endpoint to be configured.
If you entered everything correctly, the provsioning will complete with this message.
If you receive an error message, please double-check that you have entered everything correctly. Should you be unable to provision the endpoint, consult the network section in order to verify that your network is configured to allow connection to our servers.
Please don't hestitate to get in touch if you need any assistance.